SC 330 Commissioning Frick Screws

SC 330 – Mechanical Commissioning

SC 330 provides a step‑by‑step, field‑focused guide to mechanically commissioning FRICK® screw compressor packages. The course is built around real startup conditions and addresses the most common causes of premature failures, delays, and warranty disputes.

This course is designed for:

• Compressor startup and service technicians
• Installation supervisors and contractors
• Engineers responsible for commissioning or acceptance
• Maintenance personnel supporting new installations

Students learn how to inspect installations, prepare compressor packages, and commission equipment safely and methodically. The course emphasizes foundation integrity, piping strain, wiring practices, oil system preparation, alignment, rotation checks, and controlled startup procedures.

Course Sections

• Introduction – Before You Arrive
  Startup preparation and documentation review.

• Installation Checks – Foundation
  Verifying mass, anchoring, and leveling.

• Installation Checks – Piping
  Pipe strain, supports, slopes, and valve orientation.

• Wiring Checks
  Electrical integrity, grounding, and torque verification.

• Oil Systems
  Oil selection, fill levels, filters, and coalescers.

• Applying Power
  Safe energization and control verification.

• Motor Lubrication
  Bearing lubrication readiness.

• Starter and Rotation Checks
  Ensuring correct motor and compressor rotation.

• Couplings
  Installation, alignment, and magnetic center.

• Pre‑Start Checks and Test Run
  Controlled startup and initial loading.

• Oil Pumps
  Oil circulation support and troubleshooting.

• Main Oil Injection Valve
  Critical adjustment during startup.

• Vibration Analysis
  Baseline measurements and resonance control.

• High Pressure Cutout
  Safety device verification.

• Final Commissioning
  Final checks, documentation, and operational handoff.

Outcome:
After completing SC 330, technicians can confidently commission compressors, prevent startup damage, reduce vibration and oil issues, and deliver a mechanically sound machine ready for long‑term service.